Start backtacks
●
If this key is pressed, the backtack function at the beginning of the seam (start backtacks)
is switched on or off. The number of forward stitches (A) or reverse stitches (B) for the
start backtacks can be changed respectively by pressing the +/- key underneath. To con-
vert from double backtack to single backtack, reset the number of stitches for the corres-
ponding seam section. It is also possible to select 4 different special backtacks.
End backtacks
●
If this key is pressed, the backtack function at the end of the seam (end backtacks) is
switched on or off. The number of reverse stitches (C) or forward stitches (D) can be
changed respectively by pressing the +/- key underneath. To convert from double backt-
ack to single backtack, reset the number of stitches for the corresponding seam section.
It is also possible to select 4 different special backtacks.
Needle position
●
If this key is pressed the "needle raised after sewing stop" function is switched on or off.
When the function is switched on, the needle positions at t.d.c. after sewing stops.
Foot position after stop
●
If this key is pressed the "foot raised after sewing stop" function is switched on or off.
When the function is switched on, the presser foot is raised after sewing stops.
Foot position after trimming
●
If this key is pressed the "foot raised after thread trimming" function is switched on or
off. When the function is switched on, the presser foot is raised after thread trimming.
Thread trimmer
●
If this key is pressed the thread trimming function is switched on or off.
Stop at the left needle penetration point
●
If this key is pressed, the corresponding function is switched on or off. When the func-
tion is switched on, the machine always positions at the left needle penetration point of
the zigzag seam. The function is only carried out when the blind stitch function is swit-
ched off.
Stop at the right needle penetration point
●
If this key is pressed, the corresponding function is switched on or off. When the function
is switched on, the machine always positions at the right needle penetration point of the
zigzag seam. The function is only carried out when the blind stitch function is switched
off.
Straight stitch
●
If this key is pressed, the corresponding function is switched on or off. When the func-
tion is switched on, the standard "straight stitch" pattern is sewn, see Chapter 10.02.01
Straight stitch.
Controls
21