Innova Can OBD2 Owner's Manual page 56

Live Data Mode
LIVE DATA PLAYBACK
1. With the Scan Tool not connected to a vehicle, press the
POWER/LINK
The "To Link" screen shows on the
Scan Tool's display.
2. Press the ENTER/LD
place the Scan Tool in "Live Data
Playback" mode.
The display shows the recorded
Live
"trigger" frame.
When you select Yes from the Record Live Data confirmation
screen, the Scan Tool enters the "Live Data Playback" mode,
and the display shows the recorded Live Data, beginning with
the "trigger" frame.
A vehicle usually supports several PIDs, however, only a limited
amount of PID data can be displayed on the screen at one time.
If additional PID data is available, a small arrow will be shown on
the display. Use the UP
necessary, to scroll up or down to view all available PID data.
When viewing recorded Live Data, look for any irregularities in
any of the PID values/signal information (LTFT %, RPM, MAP,
TEMP, etc.). If any PIDs are not within specification, or
irregularities are detected, follow the procedures in the vehicle's
service repair manual to perform additional troubleshooting and
repair.
When recorded Live Data is played back, all available PIDs
are shown, even if you have customized the Live Data
selections.
If there is no Live Data currently stored in the Scan Tool's
memory, an advisory message shows on the display. Press
the DTC SCROLL
mode.
3. When you have viewed all PID information for the current frame of
Live Data, use the DOWN
list. Highlight Next Frame or Previous Frame, as desired, then press
the ENTER/LD
4. When you have finished viewing the recorded Live Data, exit the
"Live Data Playback" mode using the appropriate procedure shown
below:
If the Scan Tool is connected to a vehicle, use the DOWN
button to scroll to the end of the PID list, highlight Exit Playback,
then press the ENTER/LD
If the Scan Tool is not connected to a vehicle, press the DTC
SCROLL
54
button.
Data, beginning
button.
button.
button to
with the
and DOWN
button to exit the "Live Data Playback"
button to scroll to the end of the PID
button.
buttons, as
OBD2