Boiler Jacket - Pack A - Buderus SB735 Series Installation And Maintenance Manual

Boiler Assembly
6.2

Boiler Jacket - Pack A

Locate the front cross bracket (trapezoidal cut-out
down) with its two top holes on the threaded studs
and secure with nuts (Fig. 9).
Locate the rear cross bracket (V-shaped cut-out
J NOTICE!
down) with its two top holes on the threaded studs
and secure with nuts (Fig. 9).
The edge of the cross bracket must point
outwards (Fig. 9).
Insert the insulation blanket from the burner door
(Fig. 7, Item. 2) and the rear side (Fig. 8, Item. 2) into
the upper edge and the front and rear cross bracket.
Lightly insert two screws M8 x 80 (Fig. 10, Item. 3)
from the top into the central cross bracket (Fig. 10,
Item.1).
Secure the central gross bracket (Fig. 10, Item. 1) at
J NOTICE!
the top to the fixing bracket using two bolts, washers
and nuts (Fig. 10, Item. 2).
Ensure that the edge of the central cross
bracket (Fig. 10, Item. 1) points forward.
Lightly secure the central cross bracket front (Fig. 9,
J NOTICE!
Item.1) on the left and the right side using two bolts
and washers.
Initially secure the central cross bracket (Fig. 9,
Item. 1) only lightly. Tighten the cross brackets
after they have been aligned and secured to the
side wall closest to the front.
Push the strain relief (Fig. 10, Item. 4) on the hinge
side of the burner door into the cross bracket.
Secure the strain relief with two bolts (Fig. 10).
We reserve the right to make any changes due to technical modifications!
Boiler Installation and Maintenance Manual SB735 • Issue 10/2003
1
Cross brackets
Fig. 9
3
6
5
Fig. 10 Strain relief
Item. 1: Central cross bracket
Item. 2: Fixing bracket
Item. 3: M8 x 80 bolts
Item. 4: Strain relief
Item. 5: Bolt location central cross bracket for boiler models
790 and 970
Item. 6: Bolt location central cross bracket for boiler model
1200
Buderus Heiztechnik GmbH • http://www.heiztechnik.buderus.de
6
1
1 2
3
4
11