Magnum 6KQ Managed Field Switch Installation and User Guide
Switch, the fiber port supports fiber optic cable distances up the IEEE-standard 10Mbps
distance limits, i.e., typically 2km at full-duplex and half-duplex.
Each port has an Activity (ACT) LED indicating packets being received, a
Link (LK) LED that indicates proper connectivity with the remote device when lit, and
an FDX/HDX LED to indicate full-duplex mode when lit (or half-duplex when off).
5.2.2. 6KQ2-MSC, 2@100Mb multi-mode FX-SC "snap-in" Fiber
connector
The Magnum 6KQ2-MSC is two port module equipped with 2 multi-mode
100Mbps fiber optic transceivers. This is similar to the 6KQ2-MST. It has the same
LEDs indicating port activity (ACT), Link (LK), and FDX / HDX and 10/100 operation,
as well as the same face-plate lettering. The difference is that the 6KQ2-MSC is
equipped with SC-type "snap-in" fiber port connector instead of an ST-type.
5.2.3
6KQ2-SSCL, 2 Ports @100Mbps single-mode FX-SC-type, Sgl.M
The Magnum 6KQ2-SSCL is also a Fiber module equipped with 2 Single-mode (Long
Reach) SC-type connectors. It
provides a long reach Fiber
function in one module to the
6KQ Switches, supporting
100Mb single-mode (Long-
Reach) fiber network segments.
The 6KQ2-SSCL,
when installed in a Magnum
6KQ Switch, supports single-
mode fiber cable lengths of as much as 40+ Km (see Power Budget, Section 4.5). Each
port has an
Activity (ACT) LED indicating packets being received, a Link (LK) LED indicating
proper connectivity with the remote device when lit, and a FDX/HDX LED indicating
full-duplex mode when lit (or half-duplex when off).
www GarrettCom com
.
.
37
(04/07)