Table of Contents
Advertisement
Magnum 6KQ Managed Field Switch Installation and User Guide
(04/07)
except they have the capability of providing power on each port to power up the PD
devices, per the IEEE802.3af PoE standard. The power-pass-through PoE modules are
dependent upon the -48VDC input power to supply the PD power for these RJ-45
(10/100) ports. Each port supplies up to 15watts to power the PoE PD devices. A
maximum of 8 PoE ports can be configured in the A and B slots of a 6KQ switch with -
48vdc power input. The PoE modules are also available with mix–n-match fiber modules
configured in other 6KQ slots. Please check the Configuration Guide and the ordering
information Sec.1.2 for all the various P6K PoE module options.
The LEDs on P6KQ4-RJ45- PoE modules are slightly different compared to regular
(non-PoE) RJ-45
modules as shown in Fig
2. When the PoE port is
in use, the PoE LED is
ON when connected
properly to an 803.af
compliant PD device on that port. When non-PoE devices are connected, the PoE LED is
OFF. The operation of Ethernet data traffic is not affected by PoE.
LINK and ACTIVITY LEDS are combined on the PoE modules into one LED that is
marked as LINK/ACT, as shown in the diagram.
2.2.4 Two-Port Fiber Modules, 2@ 100Mb fiber
The two-port modules are available as two 100Mb fiber ports. ST or SC connector
styles are available utilizing multi-mode or single-mode fiber optics. These fiber
modules may be factory configured with a choice of them in slot B and D only.
The fiber port's LEDs indicate status the same as the SFF fiber modules in Section 2.2.2
above. Color-coding on the panel of the module shows which LEDs belong to which
port.
2@ 100 Mb SC
2@ 100 Mb ST
www GarrettCom com
.
.
11
Advertisement
Table of Contents
