Electronic Pilot Ignition Wiring; Remote Wall Mounted Switch; Optional Dc Remote System - Monessen Hearth MDV500 Installation And Operating Instructions Manual

ELECTRICAL INSTALLATION

ELECTRONIC PILOT IGNITION WIRING

Ignition Module (Synetek)
15' Wall Switch Wire
BLACK
WHITE
REMOTE WALL SWITCH
Position the wall switch. Do not extend beyond the 15 feet of wire.
OPTIONAL DC REMOTE SYSTEMS
These instructions replace the section entitled Hearth Mount in the Millivolt hand held remote instructions supplied with
the remote.
1. Follow instructions on remote control to snap remote cover plate to remote receiver.
2. Connect the wire terminal from the remote receiver. This replaces the 15' wall switch connection to the switch. See
Figure 41.
3. Use screws that came with remote control to mount remote control receiver at junction box (for your wall switch) or at
control panel (when installation in unit is preferred).
32
Do not connect 110-120 VAC to the
Remote Wall Switch. The appliance
will malfunction.
Electronic Valve
WHITE #3
EV1
Figure 41 - Electronic Ignition System Wiring Diagram
Spark
Sense
HI
GRAY #7
EV2
RS
OFF
ON
Pilot Assembly
WHITE
MAGENTA #5
WHITE
BLUE
BLUE #1
YELLOW
To Junction Box
GREEN
BLACK
BLACK
Primary - 120V
Transformer
Secondary
24V
YELLOW
75D2523