Table of Contents
Advertisement
ELECTRICAL INSTALLATION
ELECTRONIC PILOT IGNITION WIRING
REMOTE WALL SWITCH
Position the wall switch. Do not extend beyond the 15' of wire.
OPTIONAL DC REMOTE SYSTEMS
These instructions replace the section entitled Hearth Mount in the Millivolt hand held remote instructions supplied with
the remote.
1. Plug in remote connector wire to remote receiver.
2. Connect the wire terminal from the remote receiver. This replaces the 15' wall switch connection to the switch. See
Figure 20.
3. Mount remote control receiver at junction box (for your wall switch).
22
Do not connect 110-120 VAC to the
Remote Wall Switch. The appliance
will malfunction or destroyed.
Figure 20 - Electronic Ignition System Wiring Diagram
62D4036
Advertisement
Table of Contents
