Table of Contents
Advertisement
Feature Select Programming Method
After entering certain sections, eight options will be displayed where each option from [1] to [8] represents a specific feature. Press
the key corresponding to the desired option and the option number will appear in the LCD screen. This means the option is ON.
Press the key again to remove the digit from the LCD screen (a * appears), thereby, turning OFF the option. Press the [*] key to set
all eight options to OFF. When the options are set, press the [#] key to save and advance to the next section.
Decimal and Hexadecimal Values
Hexadecimal only
values:
[1] = A
[2] = B
[3] = C
[4] = D
[5] = E
[6] = F
Decimal and
Hexadecimal
Values:
Keys [0] to [9] = 0
to 9
Installer Quick Keys
To access the Installer Quick keys, press and hold the [0] key from the Main keypad, enter the [
Center keypad:
Key [1] =Test Report: Send the "Test Report" report code programmed in section [171] (page 12) to the monitoring station.
Key [2] =Cancel Communication: Cancels all communication with the WinLoad software or with the monitoring station until the next
reportable event.
Key [3] =Answer WinLoad Software: Will force the console to answer an incoming call from the monitoring station that is using the
WinLoad software.
Key [4] =Call WinLoad Software: Will dial the PC telephone number programmed in section [115] (page 10) in order to initiate
communication with a computer using the WinLoad software.
Key [5] =Installer Test Mode: The installer test mode will allow you to perform walk tests where the siren will squawk to indicate opened
zones. Press the [5] key again to exit.
Magellan
Figure 1: Decimal and Hexadecimal Values
] and then press from the
INSTALLER CODE
3
Hide quick links:
Advertisement
Table of Contents
