Table of Contents
Advertisement
TG106xC(e).book Page 39 Wednesday, February 25, 2009 11:13 AM
Wall mounting
Base unit
1
Connect the AC adaptor and telephone line
cord. Tuck the telephone line cord inside the
wall mounting adaptor, then push it in the
direction of the arrow.
L The word "UP" should face upward.
2
Connect the telephone line cord. Mount the
unit by inserting the mounting pins into the
round openings on the adaptor (for pin 2, use
the round cut out at the bottom of the adaptor
if you are using the 4 inch phone plate), then
slide the unit down to secure it. Connect the
AC adaptor to power outlet (page 8).
L There are 2 common types of wall phone
plates. The distance between 1 and 2
may vary depending on the size of the wall
phone plate installed.
Useful Information
Charger
1
Drive the screws (not supplied) into the wall.
25.4 mm
(1 inch)
Screws
(120 V AC, 60 Hz)
2
Mount the charger (A), then slide it down (B)
and to the right (C) until it is secure.
A
B
Belt clip
■ To attach
■ To remove
C
39
Hide quick links:
Advertisement
Table of Contents
