KX-TG1061CM/KX-TGA106CM 1 Safety Precautions 1.1. For Service Technicians • Repair service shall be provided in accordance with repair technology information such as service manual so as to prevent fires, injury or electric shock, which can be caused by improper repair work.
KX-TG1061CM/KX-TGA106CM 3 Specifications Note: • Design and specifications are subject to change without notice. Note for service: • Operation range: Up to 300 m outdoors, Up to 50 m indoors, depending on the condition. • Optional headset: RP-TCA86, RP-TCA94, RP-TCA95...
KX-TG1061CM/KX-TGA106CM 5 Installation Instructions 5.2. Battery 5.2.1. Battery Installation 5.1. Setting up 5.1.1. Connections Note: • The AC adaptor must remain connected at all times. (It is Note for service: normal for the adaptor to feel warm during use.) The battery strength may not be indicated correctly if the •...
• The batteries need to be charged if the cordless handset beeps while you are engaged in a call or operating the answering system remotely. 5.2.4. Panasonic Ni-MH Battery Perfor- mance (supplied batteries) Note: • Actual battery performance depends on a combination of how often the handset is in use and how often it is not in use (standby).
KX-TG1061CM/KX-TGA106CM 6 Operating Instructions 6.1. Programmable settings You can customize the unit by programming the following features. To access the features, there are 2 methods: - scrolling through the display menus. - using the direct commands. • Direct command is the main method used in this service manual.
KX-TG1061CM/KX-TGA106CM 6.3. Copying Phonebook Entries You can copy phonebook entries from the base unit to a cordless handset , and vice versa. Important: • Groups (including their names and ringer tones) are not copied. • You cannot make phonebook copy between cordless handsets directly.
KX-TG1061CM/KX-TGA106CM 6.6. Troubleshooting If you still have difficulties after following the instructions in this section, disconnect the base unit’s AC adaptor, then reconnect the base unit’s AC adaptor. Remove the batteries from the cordless handset, and then insert the batteries into the cordless handset...
KX-TG1061CM/KX-TGA106CM 7 Schematic Diagram 7.1. For Schematic Diagram 7.1.1. Base Unit (Schematic Diagram (Base Unit_Main)) Notes: 1. DC voltage measurements are taken with voltmeter from the negative voltage line. 2. The schematic diagrams may be modified at any time with the development of new technology.
Page 25
KX-TG1061CM/KX-TGA106CM W 0.15mm L 20+/-2mm 3rd layer R807 RXON L801 C827 TP_ANT1 RX_RF C826 RF_RXn *C859 C803 1.5p DA801 RF_RXp W 0.125mm L 7.6mm CP+3.0V Gap 0.125mm W 0.15mm W 0.15mm 1st layer L 5.0mm L 5.0mm 1st layer 1st layer C172 K0.1u...
STAND, WALLMOUNT ABS-HB PNHS1079Z SPACER, BATTERY COVER PNKK1027Z1 LID, BATTERY PNLC1008ZM CHARGER UNIT ASS'Y (RTL) Note: (*1) The rechargeable Ni-MH batery HHR-4DPA is available through sales route of Panasonic. (*2) Attach the SPACER (A9) to the exact location described above.
SPACER, BATTERY COVER A105 PNKK1027Z1 LID, BATTERY A106 PNLC1008ZM CHARGER UNIT ASS'Y (RTL) Note: (*1) Attach the SPACER (A104) to the exact location described above. (*2) The rechargeable Ni-MH batery HHR-4DPA is available through sales route of Panasonic. KXTG1061CM KXTGA106CM...