Non-Locking Trunnion Installation - Motorola MaxTrac 100 Operating Instructions Manual

Motorola maxtrac mobile radios operating instructions

Hide thumbs Also See for MaxTrac 100:

Operating instructions (2 pages)

Table Of Contents

Table of Contents

Non–Locking Trunnion Installation

(1)

Select the location to mount your radio either on the TRANSMISSION HUMP

OR BELOW THE DASH (see Figure 4).

(2)

Using the trunnion-mounting bracket as a template, mark the positions of

the holes on the mounting surface. Use the innermost four holes for a

curved mounting surface such as the transmission hump, and the four

outmost holes for a flat surface such as under the dash.

(3)

Centerpunch the spots you have marked and drill a 5/32" hole at each.

(4)

Secure the trunnion-mounting bracket to the surface with the four (10-

16x3/4") screws provided.

(5)

Place the radio in the trunnion-mounting bracket and secure it with the two

thumb screws provided.

(6)

To complete your radio installation, plug the power cable into the radio

power connector (see Figure 3).

(7)

Mount the antenna using the instructions provided with the antenna kit. Run

the coaxial cable to the radio mounting location. If necessary, cut off the

excess cable and install the cable connector.

(8)

Connect the antenna cable connector to the radio antenna connector on the

rear of the radio (see Figure 3).

(9)

Mount the microphone clip. Follow instructions provided with the

microphone clip.

Begin Installation (cont.)