Activating The Call List For Sending Selective Messages; Selecting Call-List Letters And Id Numbers; Sending A Signalling Message - Motorola MaxTrac 100 Operating Instructions Manual

Activating the Call List for Sending Selective Messages

Pressing the Select button (Call button on 900MHz 6-channel model) will activate
the call list. The most recently used ID number and the call letters will alternately
be displayed. The following call letters may be displayed:
SC – Voice Selective Call: Call a particular unit or group with a voice message.
CA – Call Alert: Select a unit or group and leave a "call-back" indicator.
CH – Radio Check: Check to see if a unit is turned on and within range.
Note: The first time the call list is activated after power-up, the first ID on the call
list will be displayed.
Tx/Bsy Mon
Mon
MaxTrac 300

Selecting Call-List Letters and ID Numbers

Each press of the Select button (Call button on 900MHz 6-channel model) causes
the display to move down the list of call letters which have been programmed in
the radio.
Pressing the Up ( ) or Down ( ) buttons will scroll through the ID numbers. All
call list ID numbers will be displayed with each set of call letters. However, some
IDs may not be compatible with certain call types. For example, a group ID cannot
be radio checked. In such cases, pressing the PTT button will result in an invalid
operation.

Sending a Signalling Message

Once the desired call letters and ID numbers have been selected, pressing the
PTT button will send the message. The display will revert to the pre-programmed
transmit channel to send the signalling message, and the channel will be briefly
displayed while the message is being transmitted.
12 MaxTrac 100/300 Operation (cont.)
Signalling Operation (cont.)
Pri
Pri
Usr
Scan
Scan Select
Tx/Bsy Mon
Mon Call H/L
900MHz MaxTrac 300
(6-Channel)