Pre-Programmed Scan; User-Programmable Scan - Motorola MaxTrac 100 Operating Instructions Manual

Pre–Programmed Scan
Each active channel in the radio can have a pre-programmed scan list dedicated to it.
Through the use of radio service software (RSS) and a computer at a service location,
any combination of sequential frequencies may be programmed into each active list.
Priority one is always assigned to the selected channel. Priority two can be designated
by the servicer or deleted altogether. However, the radio can only have one designated
priority–two channel. Therefore, priority two must be the same channel in each scan
list. For example, if channel three has been programmed as the second priority in a
scan list, channel three will be the second priority channel in the remaining active scan
lists.
The MaxTrac 300 16-channel and 32-channel radio scans at a rate of approximately
250 milliseconds per channel. Therefore, scanning more than eight frequencies is not
recommended.
User–Programmable Scan
A single user-scan list (one per radio) can be programmed from the front panel by the
operator and will be retained in memory until changed or deleted. This is separate
from the scan lists pre-programmed to each active channel.
To create or modify the user-scan list, hold the Scan button down for 2 seconds until
you hear a second chirp tone. The channel number will flash. Add or delete this
channel from the list by pressing the Select button.
Pri
Usr
Scan
Use the Up ( )/Down ( ) and Select buttons to add or delete desired channels in
the user list.
To select priorities for the user list, go to the desired channel and hold the Select
button down for 2 seconds. The priority (Pri) LED will flash to indicate that the
displayed channel is designated as the priority one channel. Repeat the process to
select a priority two channel, if desired, which will be indicated by a steady light on the
priority (Pri) LED.
It's important to note that the priority–one channel is programmed first followed by the
priority–two channel. To set different priorities, deleting either one will delete both
priority channels at the same time. Then, reset priority channels as described above.
16 Channel Scan
Pre–Programmed Scan /
User–Programmable Scan
A vertical segment in the upper left corner of the display will
light to indicate that the flashing channel has been added to
the user-scan list. It will disappear when the channel is
deleted.
TM Feature (cont.)