2.5 Outdoor wall mount installation
Note:
If you install the camera on the ceiling, ensure that the ceiling is strong enough to withstand three
times weight of the camera and then install the camera securely. If the ceiling is not strong enough, the
camera may fall and cause serious injury.
1. Loosen the set screws with a hexagonal screw
driver (attached with the camera), and remove
the dome cover.
2. Loosen the inside set screws located around
the dome core, and remove the dome core
gently.
3. Install bracket DS‐1242ZJ or DS‐1243ZJ on the
wall. In this step, as shown in the figure, you
should screw dome core screws through
mounting screw.
4. Install the dome base first. Tighten the screws
to the mounting surface.
5. Install the dome core to the dome base and
tighten the screws.
6. Adjust desired focus and scene by turning and
moving the 3‐axis camera bracket by hand.
7. Install black cover.
8. Install the dome cover and fix with dome cover
screw.
Note: If it is cement wall, user need to use expansion screw. Position of screw installation should be
same as dome.
Following is DS‐1242ZJ and DS‐1243ZJ
11