Installing Forms Using The Did Option; Figure 2-20. Dod Option With Roller Drive; Figure 2-21. Forms Handler Module (Did Option) - MTX 1330-X02 Operator's Manual

drive. The bars will snap into the OFF position, as shown in Figure 2-20.
Next is the procedure for using the Document Insertion Device (DID) option.

Installing Forms Using the DID Option

Refer to Figure 2-21 for a picture of the Forms Handler module set for the DID option. In
this procedure, first set up the module for forms loading, next insert the module into the
printer, and finally load the forms into the printer.
1. Make sure the printer power is on, and the printer is in Stop mode.
2. For ease of handling, lay the module on top of the printer.
701333-004
Paper Supports
Slide Bar

Figure 2-20. DOD Option with Roller Drive

Paper Supports

Figure 2-21. Forms Handler Module (DID Option)

Preparing to Operate the 1330
Roller Drive
Shown OFF
Slide Bar
2-23