Figure 7-1. Replacing The Print Head; Figure 7-2. Carriage Restraining Hook - MTX 1330-X02 Operator's Manual

Note: Print head style 2 has a connector at the top of the print head. This connector
does not have to be disconnected when you remove the print head.
Note: Take care that the wiring from the ribbon select motor stays through the carriage
restraining hook. Refer to Figure 7-2.
10. If it is installed, remove the tie-wrap holding the print head wires to the carriage.
701333-004
Connectors

Figure 7-1. Replacing the Print Head

Figure 7-2. Carriage Restraining Hook

Maintaining the 1330
Restraining Hook
7-3