Connecting A Parallel Or Serial Cable; Connecting A Parallel Cable; Connecting A Serial Cable; Figure 2-9. Connecting A Parallel Or Serial Cable - MTX 1330-X02 Operator's Manual

Preparing to Operate the 1330

Connecting a Parallel or Serial Cable

To comply with FCC regulations, use one of the following cables:
• Parallel cable – MTX P/N 956588-001 (36-pin, 6 ft. EIA).
• RS-232 serial cable – This is available as P/N 957520-010 (10 feet). For other RS-232
or RS-422 applications, use locally available cables.
Before you connect the cable, make sure the Power switch is in the O (OFF) position.

Connecting a Parallel Cable

Push the male end of the parallel cable into the parallel receptacle on the back of the
1330 (see Figure 2-9). Push the wire guards, located at each end of the receptacle, in,
over the cable end, to hold the cable in place.

Connecting a Serial Cable

Loosen the screws at each end of the serial receptacle on the back of the 1330 (see Figure
2-9). Push the male end of the serial cable into the serial receptacle. Tighten the screws
to hold the cable in place.
2-10
Wire Guards
Parallel Receptacle
Serial Receptacle
Screws

Figure 2-9. Connecting a Parallel or Serial Cable

701333-004