INSPECTION AND REASSEMBLY
Inspect the boots for wear or damage. If any defects are found,
replace them with new ones.
Inspect the axle play by using a push-and-pull motion as shown.
NOTE:
* Clean the disassembled parts (except for the boots). After
Cleaning, completely dry the parts using compressed air.
* Clean the boots with a cloth.
#
* Clean al l p arts be fore i nstallation, cl ean th e ins ide
and outside of the boots with a cloth.
* Do not wash the boots in any commercially available
degreaser, such as gasoline or kerosene. Washing in
a degreaser causes deterioration of the boots.
• Fit a boot on the drive shaft end, fitting the small diameter side
of the boot to the shaft groove, fix its end with the boot band.
#
The removed boot band must be replaced with a ne w
one.
• Install the cage 1 on the shaft.
#
Install the cage with the large diameter side facing the
shaft end.
A Large diameter
B Small diameter
CHASSIS
8-23