Telephone Base And Charger Installation; Telephone Base Installation; Charger Installation - AT&T CL82203 User Manual

Getting started

Telephone base and charger installation

Install the telephone base and charger as shown below.
The telephone base is ready for tabletop use. If you want to change to wall
mounting, see Installation options on page 10 for details.

Telephone base installation

•
Plug the large end of
the telephone base
power adapter into
a power outlet not
controlled by a wall
switch.
•
Raise the antenna.

Charger installation

IMPORTANT INFORMATION
1. Use only the power adapters supplied with this product. To order a replacement
power adapter, visit our website at
1 (800) 222-3111
2. The power adapters are intended to be correctly oriented in a vertical or floor
mount position. The prongs are not designed to hold the plug in place if it is
plugged into a ceiling, under-the-table or cabinet outlet.
Telephone line cord
Plug the power adapter into a power outlet not
controlled by a wall switch.
www.telephones.att.com
1 (866) 288-4268
. In Canada, dial
7
•
Plug the other end of the telephone line
cord into a telephone jack or a DSL filter.
•
•
•
If you have DSL
high-speed Internet
service, a DSL filter
(not included) is
required. The DSL
filter must be
plugged into the
telephone wall jack.
Route the power
adapter cord and the
telephone line cord
through the slots.
Plug one end of the
telephone line cord
into the telephone
jack on the back of
the telephone base.
Plug the small end of
the telephone base
power adapter into
the power adapter
jack on the back of
the telephone base.
or call
.