Functional Parts(Tv) - Akai ALD1670 Operator's Manual

FUNCTIONAL PARTS(TV)

Front View of LCD Set
15
¼ ò ½ é
To turn the TV power ON
Put the TV set on the correct place, then connect the DC plug of the AC-DC adaptor to the DC 12V socket
at the left side of the TV set. Connect the adaptor main cord to the wall outlet ,then the LED indicator lamp
turns red and the TV set is at Standby/work Mode. At Standby Mode, if Standby Button is pressed
the power indicator will change to green. It takes a few seconds before the picture appears.
To turn the TV power OFF
Press the Standby Button to make the TV set in Standby Mode, then disconnect the power plug from the
wall outlet.
NOTE
If TV is the selected input without signal received and NO operation is performed for about 5 minutes
continuously, the TV set will enter standby mode. For any inputs other than TV, the TV set will not enter
standby mode automatically without users instruction. If you are not going to use this TV set for a long
time, switch off the set and disconnect the power plug from the wall outlet.
V-
9
14 13 12 11 10
1 3
V+ P- P+ MENU SOURCE
8 7 6 5 4
2
1. LED indicator lamp
2. Remote Sensor
3. Standby Button
4. SOURCE Button
5. MENU Button
6. P+ Button
7. P- Button
8. V+Button
9. V- Button
10. Repeat
11. Next
12. Preview
13. Play/Pause
14. Stop
15. Open/Close
9