Cisco Catalyst 3750-X Software Configuration Manual page 742

Configuring LLDP, LLDP-MED, and Wired Location Service
Command
Step 3
lldp med-tlv-select tlv
Step 4
end
Step 5 copy running-config startup-config
This example shows how to enable a TLV on an interface:
Switch# configure terminal
Switch(config)# interface interface_id
Switch(config-if)# lldp med-tlv-select inventory-management
Switch(config-if)# end
Configuring Network-Policy TLV
Beginning in privileged EXEC mode, follow these steps to create a network-policy profile, configure the
policy attributes, and apply it to an interface.
Command
Step 1
configure terminal
Step 2
network-policy profile profile number
{voice | voice-signaling} vlan [vlan-id
Step 3
{cos cvalue | dscp dvalue}] | [[dot1p
{cos cvalue | dscp dvalue}] | none |
untagged]
Step 4
exit
Step 5
interface interface-id
Step 6
network-policy profile number
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
30-8
Chapter 30 Configuring LLDP, LLDP-MED, and Wired Location Service
Purpose
Specify the TLV to enable.
Return to privileged EXEC mode.
(Optional) Save your entries in the configuration file.
Purpose
Enter global configuration mode.
Specify the network-policy profile number, and enter network-policy
configuration mode. The range is 1 to 4294967295.
Configure the policy attributes:
voice—Specify the voice application type.
voice-signaling—Specify the voice-signaling application type.
vlan—Specify the native VLAN for voice traffic.
vlan-id—(Optional) Specify the VLAN for voice traffic. The range is
1 to 4094.
cos cvalue—(Optional) Specify the Layer 2 priority class of service
(CoS) for the configured VLAN. The range is 0 to 7; the default is 0.
dscp dvalue—(Optional) Specify the differentiated services code
point (DSCP) value for the configured VLAN. The range is 0 to 63;
the default is 0.
dot1p—(Optional) Configure the telephone to use IEEE 802.1p
priority tagging and use VLAN 0 (the native VLAN).
none—(Optional) Do not instruct the IP telephone about the voice
VLAN. The telephone uses the configuration from the telephone key
pad.
untagged—(Optional) Configure the telephone to send untagged
voice traffic. This is the default for the telephone.
Return to global configuration mode.
Specify the interface on which you are configuring a network-policy
profile, and enter interface configuration mode.
Specify the network-policy profile number.
OL-21521-01