Configuring 802.1X Authentication With Wol; Configuring Mac Authentication Bypass - Cisco Catalyst 3750-X Software Configuration Manual

Configuring 802.1x Authentication
Switch(config-if)# dot1x critical
Switch(config-if)# dot1x critical recovery action reinitialize
Switch(config-if)# dot1x critical vlan 20
Switch(config-if)# end

Configuring 802.1x Authentication with WoL

Beginning in privileged EXEC mode, follow these steps to enable 802.1x authentication with WoL. This
procedure is optional.
Command
Step 1
configure terminal
Step 2 interface interface-id
dot1x control-direction {both | in}
Step 3
Step 4
end
Step 5
show authentication interface-id
or
show dot1x interface interface-id
Step 6 copy running-config startup-config
To disable 802.1x authentication with WoL, use the no dot1x control-direction interface configuration
command.
This example shows how to enable 802.1x authentication with WoL and set the port as bidirectional:
Switch(config-if)# dot1x control-direction both

Configuring MAC Authentication Bypass

Beginning in privileged EXEC mode, follow these steps to enable MAC authentication bypass. This
procedure is optional.
Command
Step 1
configure terminal
Step 2 interface interface-id
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
11-56
Chapter 11
Purpose
Enter global configuration mode.
Specify the port to be configured, and enter interface configuration mode.
For the supported port types, see the
Configuration Guidelines" section on page
Enable 802.1x authentication with WoL on the port, and use these
keywords to configure the port as bidirectional or unidirectional.
both—Sets the port as bidirectional. The port cannot receive packets
•
from or send packets to the host. By default, the port is bidirectional.
in—Sets the port as unidirectional. The port can send packets to the
•
host but cannot receive packets from the host.
Return to privileged EXEC mode.
Verify your entries.
(Optional) Save your entries in the configuration file.
Purpose
Enter global configuration mode.
Specify the port to be configured, and enter interface configuration mode.
For the supported port types, see the
Configuration Guidelines" section on page
Configuring IEEE 802.1x Port-Based Authentication
"802.1x Authentication
11-36.
"802.1x Authentication
11-36.
OL-21521-01