Cisco Catalyst 3750-X Software Configuration Manual page 421

Chapter 13 Configuring Interface Characteristics
Beginning in user EXEC mode, follow these steps to configure and manage the RPS 2300:
Command
power rps switch-number name {string | serialnumber}
Step 1
power rps switch-number port rps-port-id mode {active |
Step 2
standby}
power rps switch-number port rps-port-id priority priority Set the priority of the RPS 2300 port. The range is
Step 3
Step 4 show env rps
Step 5
copy running-config startup-config
OL-21521-01
Configuring the Cisco RPS 2300 in a Mixed Stack
Purpose
Specify the name of the RPS 2300.
The keywords have these meanings:
switch-number—Specify the stack member to
•
which the RPS 2300 is connected. The range
is 1 to 9, depending on the switch member
numbers in the stack. This keyword is supported
only on Catalyst 3750-E switches.
name—Set the name of the RPS 2300 and enter
•
one of these options:
string—Specify the name such as port1 or
–
"port 1". Using quotation marks before and
after the name is optional, but you must use
quotation marks if you want to include
spaces in the port name. The name can have
up to 16 characters.
serialnumber—Configure the switch to
–
use the RPS 2300 serial number as the
name.
Specify the mode of the RPS 2300 port.
The keywords have these meanings:
switch-number—Specify the stack member to
•
which the RPS 2300 is connected. The range
is 1 to 9, depending on the switch member
numbers in the stack. This keyword is supported
only on Catalyst 3750-E switches.
port rps-port-id—Specify the RPS 2300 port.
•
The range is from 1 to 6.
mode—Set the mode of the RPS 2300 port:
•
active—The RPS 2300 can provide the
–
power to a switch when the switch internal
power supply cannot.
standby—The RPS 2300 is not providing
–
power to a switch.
The default mode for RPS ports is active.
from 1 to 6, where 1 is the highest priority and 6 is
the lowest priority.
The default port priority is 6.
Verify your settings.
(Optional) Save your entries in the configuration
file.
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
13-43