Displaying The Channel Banner; Understanding The Auto Power Off Feature; Understanding The Last Mode Memory Feature; Using The Gray Level Feature - Toshiba 56MX195 Owner's Manual

Displaying the Channel Banner

To display the channel banner:
Press RECALL on the remote control.
The following information will display in the channel banner
(if applicable):
• Current input (ANT 1, ANT 2, VIDEO 1, etc.)
• If ANT 1 or ANT 2 is the current input, whether it is
Cable TV ("CABLE") or
off-air ("TV")
• Channel number (if in
ANT 1 or ANT 2 mode)
• Signal strength indicator
(bar graph in lower right
corner of banner; for
ATSC signal only)
Note: The signal strength indicator will react to fading and
increasing signals and could display longer than the normal
channel banner screen.
• Time (if set)
• On/Off timer settings (if set)
• Remaining time on sleep timer (if set)
• Remaining time on game timer (if set)
• Stereo or SAP audio status
• V-Chip rating status
• Picture size
• Tuner hold* (if applicable)
*If you are recording on one tuner (for example, the digital
tuner), you will be able to change channels on the other tuner
only (the analog tuner in this example). The tuner from which
you are recording is "on hold" (i.e., locked) so your
recordings will not be affected by channel changes.
• Aspect ratio
• Lamp mode (appears only if the TV is in Hi Bright mode)
To close the channel banner:
Press RECALL again.
96
Downloaded from www.Manualslib.com
Chapter 8: Using the TV's features
STEREO
NC-17
On Timer: Weekdays 12:00pm
Sleep Timer: 18 min.
Game Timer: 28 min.
Natural
5:32pm
1080i
Sample channel banner screen
Copyright © 2005 TOSHIBA CORPORATION. All rights reserved.
manuals search engine
Understanding the auto power off
feature
The TV will automatically turn itself off after approximately 15
minutes if it is tuned to a vacant channel or a station that
completes its broadcast for the day. This feature functions in
ANT 1 and ANT 2 modes only.
Tuner Hold: On
Understanding the last mode
memory feature
ANT 1
81-1
If the power is cut off while you are viewing the TV, the Last
CABLE
Mode Memory feature automatically turns on the TV when
the power is resupplied.
Note: You should unplug the TV's power cord if it is possible
that you will be away from the TV for an extended period of time
after the power is restored.

Using the Gray Level feature

The gray level feature will set the sidebars to three different
levels of darkness. Sidebars are the blanks spaces on either side
of a 4:3 viewing area.
To set the gray level of the sidebars:
1. Press MENU and open the Setup menu.
2. Highlight Gray Level and press •.
3. Press y or z to select your desired level of darkness
(1 – Black, 2 – Dark Gray or 3 – Gray).
Setup
PC Settings
HDMI 1 Audio
HDMI 2 Audio
Slide Show Interval
AVHD Skip Time
Gray Level
Quick Restart
Navigate
Note:
• The gray level feature does not affect video being viewed in 16:9
aspect ratio.
• When receiving a signal that has sidebars (e.g., 4:3 aspect ratio
video over a 1080i or 720p signal), the gray level feature will not be
applied to the sidebars.
1
Auto
Auto On 2
Auto Auto Auto 3
2 Sec
15 min
2
On
Select CH RTN Back EXIT Exit