Connecting A Vcr And Antenna Or Cable Tv (No Cable Box); Connecting A Camcorder - Toshiba 56MX195 Owner's Manual

Connecting a VCR and antenna or Cable TV (no Cable box)

You will need:
one signal splitter
three coaxial cables
two sets of standard A/V cables
• For better picture performance, if your VCR has S-video, use an
S-video cable (plus the audio cables) instead of the standard
video cable. However, do not connect both types of video cables
to VIDEO 1 (or VIDEO 2) at the same time or the picture
performance will be unacceptable.
• If you have a mono VCR, connect L/MONO on the TV to your
VCR's audio out terminal using the white audio cable only.
To view the antenna or Cable signal:
Select the ANT 1 video input source on the TV.*
To view the VCR:
Turn ON the VCR. Select the VIDEO 1 video input source
on the TV.*
To use the TV Guide On Screen
1. Connect the G-LINK
instructions on page 25.
2. Make sure the VCR is connected to the A/V OUT
terminals on the TV (see illustration).
3. Set the VCR to the appropriate line input (refer to your
VCR owner's manual for details), and then turn OFF the
VCR.
4. See Chapter 5 for details on setting up the TV Guide
On Screen ™
5. See Chapter 7 for details on using the TV Guide
™
On Screen

Connecting a camcorder

You will need:
one set of standard A/V cables
• For better picture performance, if your camcorder has S-video, use an
S-video cable (plus the audio cables) instead of the standard video cable.
Do not connect both an S-video cable and a standard video cable to VIDEO
3 at the same time or the picture performance will be unacceptable.
To view the camcorder video:
Select the VIDEO 3 video input source on the TV.*
______________
*
To select the video input source, press INPUT on the remote control (see page 67).
To program the TV remote control to operate other devices, see Chapter 3.
16
Downloaded from www.Manualslib.com
™ recording features:
™
cable according to the
system.
system.
Copyright © 2005 TOSHIBA CORPORATION. All rights reserved.
manuals search engine
Chapter 2: Connecting your TV
From Cable TV or antenna
Signal splitter
OUT
IN from ANT
OUT to TV
TV
Note: The VIDEO/AUDIO OUT terminals output signals from the
ANT 1, ANT 2, VIDEO 1, VIDEO 2, and VIDEO 3 terminals when the
appropriate input mode is selected.
The unauthorized recording, use, distribution, or revision of television
programs, videotapes, DVDs, and other materials is prohibited under the
Copyright Laws of the United States and other countries, and may subject
you to civil and criminal liability.
IN
OUT
Stereo VCR
VIDEO AUDIO
L
CH 3
CH 4
L
Camcorder
VIDEO AUDIO
OUT
L
R
VIDEO 3 inputs on TV right side panel
R
IN
OUT
R