Table of Contents
Advertisement
panel plug. (The dummy plug is required to restore proper functioning of the unit if the
remote panel must be disconnected for any reason in the future.)
To install the in-line plug:
1) Remove the "AC Wiring Compartment" cover (if it has not already been removed to
attach AC output wires).
2) Pop out one of the circular knock-outs in the compartment cover. (It may be
necessary to punch it out by firmly tapping it with a hammer and chisel/screwdriver.)
3) Install one of the provided cable clamps in the hole.
4) Pass the connector and cable of the remote panel through the clamp, then tighten it
down securely.
5) Snap the plug into the in-line assembly and replace the compartment cover.
Note: In order for the remote panel's Inverter On-Off switch to operate, the on-off switch on
the inverter front must be in the "ON" position. Refer to section V-B for more information on
the operation of the ON/OFF switch.
IV)
BATTERY CHARGER OPERATION AND ADJUSTMENT
A) Charger Operation
Operation of the built-in two-stage battery charger is fully automatic and the charger is
operational whenever external AC is applied.
Figure 5 illustrates a typical output curve of the charger into batteries which are deeply
depleted (and not under load, initially) as well as output when a load is applied to fully
charged batteries.
FIGURE 5: Typical Two Stage Charging Output Graph
12
U.S.A. HEADQUARTERS
P.O. Box 1306, Newport Beach, CA 92663
Phone: 714-751-0488 Fax: 714-957-1621
E-Mail: sales@newmarpower.com
www.newmarpower.com
EURO WAREHOUSE
Phone:+31-35-603-2494 Fax:+31-35-603-2149
E-Mail: newmareuro@newmarpower.com
Advertisement
Table of Contents
