Table of Contents
Advertisement
H) AC Input Wiring
Refer to Figure 3 for all AC input and output wiring options in this section and in section I.
Figure 3: AC Input and Outputs
GFCI PROTECTED DUPLEX
AC OUTLETS
INVERTER ON/OFF SWITCH
DISTRIBUTION PANEL*
WHITE - NEUTRAL
GREEN - GROUND
* See distribution panel note in
section I-2, following page
The inverter/charger is provided with a three-wire 12 AWG AC cord with molded plug . It
should be plugged into a properly grounded and over-current protected outlet which is "hot"
whenever shore or generator AC power is available. The AC input serves two functions:
1) It provides power for the internal battery charger whenever external AC is available.
2) It allows routing of an external AC source through the inverter/charger so that, by
use of a built-in automatic transfer switch, AC is available directly from the unit at all
times either from the inverter or shore/generator power.
Note: There is a set of AC wires located in the compartment on the bottom front of the unit
which is labeled "AC Wiring Compartment". These are for optional hard-wiring of AC Output
only. Do not attempt to hard-wire AC input through these wires. Applying AC from an
external source to the AC output wires will cause severe damage and void the warranty.
If hard-wiring of AC input is desired the plug may be removed. Use stranded copper 12 AWG
wire only and pay careful attention to color-coding as follows:
Black..............................Hot
White..............................Neutral
Green..............................Ground (safety, earth)
U.S.A. HEADQUARTERS
P.O. Box 1306, Newport Beach, CA 92663
Phone: 714-751-0488 Fax: 714-957-1621
E-Mail: sales@newmarpower.com
AC OUTPUT TO
BLACK - HOT
www.newmarpower.com
15 AMP TOTAL OUTPUT
(MASTER) CIRCUIT BREAKER
3' AC POWER CORD,
ATTACHED AT REAR
AC INPUT TO BATTERY CHARGER AND
AUTOMATIC TRANSFER RELAY
EURO WAREHOUSE
Phone:+31-35-603-2494 Fax:+31-35-603-2149
E-Mail: newmareuro@newmarpower.com
9
Advertisement
Table of Contents
