Table of Contents
Advertisement
The kit consists of two wiring harness; one for positive
and negative DC output wiring, another for alarm
contact wiring. Wires are pre-cut to proper length, all
necessary connectors are installed and the bundles
are neatly tie-wrapped into proper position for a simple
and professional installation.
For more information, or to order the quick connect kit,
please contact the factory and specify the number of
PM's (2-6) in the system being installed.
PM DC Quick Connect Wiring Kits Model Numbers
PM Model
2-3 PM Wire
PM-12-80
PM-24-40
PM-48-20
B)
Charger Function Board
The Chager Function option (model CFCB, works on
12, 24, and 48 VDC models) is available for installation
at the factory or purchased later for field installation.
The charger function option provides smart three-
stage temperature compensated charging of GEL and
FLOODED lead acid batteries as well as a manually
triggered "Equalize" timer for flooded-lead acid
batteries.Contact Newmar or your distributor for more
information.
If this option was factory installed, there will be a
Temp Probe and Equalize connnector installed at
the rear panel and you should receive a Charger
Function Operation Manual. If you wish to install the
charger function option, contact Newmar or your local
distributor for ordering information. Installation and
operation instructions will be provided.
With the charger function board installed, each of
the following installation/performance options are
available:
1) Three stage "smart" charging: Bulk, Absorption, Float
2) Selection of ideal charge regimen for either gel-cell
or flooded lead acid batteries
3) Installation of an optional temperature compensation
sensor for optimal charging in high/low temperature
environments
4) Installation of an equalize timer for periodic
8
P.O. Box 1306
Newport Beach
California 92663
4-6 PM Wire
Harness
Harness
QCK-3A
QCK-6A
QCK-3
QCK-6
QCK-3
QCK-6
equalization of battery plates (for use with
flooded-type batteries only)
VI) Specifications: All Models
Input: 90 - 264 VAC (universal), 50 - 60 Hz.
Power Factor: 0.95 - 0.98
Regulation (with internal or-ring diode): ± 2%
Ripple P-P: 1%
Efficiency: 86% @ full load
Output Voltage Adjustment Range: ± 10 %
Temperature Rating: -20° to +70° C derate linearly from
100% load @ 50° C to 50% load at 70° C
Altitude Operational Rating: Full output to 5,000 feet;
reduce output current 4% per 1,000 feet
above 5,000 feet; 10,000 feet maximum
Individual Model Specifications
Input Amps
Model
@ F.L.
115/230V
PM-12-80
16/8
PM-24-40
16/8
PM-48-20
16/8
Protection
Output fuse for reverse polarity
Current limit and foldback
Input circuit breaker
Over-temperature shut-down, automatic recovery
Over-voltage protection
Case Size (all models):
Dimensions: 3.5" H x 17" W* x 20.5" D
* 19" mounting brackets provided
Weight: 15.2 Lbs.
Output
Voltage
Amps
Output
Cont.
13.6
80
27.2
40
54.4
20
Phone: 714-751-0488
Fax: 714-957-1621
E-Mail: techservice@newmarpower.com
Advertisement
Table of Contents
