Learning Device Codes - AT&T U-verse User Manual

Quick Setup Guide
3B: Learning Device Codes
To use this method, you must have the original remote for the device you wish to program.
STEP 1. Press and hold the LEARN
mode keys flash in sequence, then release.
STEP 2. Press the mode key
to control. The other mode keys will stop flashing.
The red LED
on your U-verse remote will flash.
STEP 3. Place the RF Remote Control head-to-head
with your original remote (about 1" – 2" apart).
STEP 4. Press the key you want to program on your RF Remote Control once. (The first key
programmed should be the POWER
the green READY TO LEARN LED
STEP 5. Press and hold the corresponding key you want programmed from the original
remote until the RF Remote Control emits a long beep, indicating it has
"learned" the desired command. (For the first key, this should be the
POWER key.)
key until the four
1
for the device you want
2
3 SELECT KEY TO LEARN indicator
4
key.) After pressing the key to program,
5
indicator will light.
5
2
4
1
3