Advanced Features Setup
E. Change to IR Control Only (deactivate RF Control)
Your RF Remote Control is set to operate your AT&T U-verse Receiver using an RF (radio
frequency) signal. The USB Converter allows the RF signal from your RF Remote Control to
communicate with your U-verse IR receiver. If there is a problem with the Converter, you can
change to IR control only (deactivate the RF control) as follows:
STEP 1. Press and hold both the AT&T
All of the mode keys flash twice.
STEP 2. Enter 9 1 6 by using the numeric keypad on the RF Remote Control. The AT&T
key will flash once with a long beep indicating successful programming.
NOTE: To restore RF control, follow the above steps but enter 9 1 5 in Step 2.
NOTE: If the programming is interrupted or inactive for more than 15 seconds, the remote
will emit 8 short beeps and the mode keys will flash. This indicates the remote has left the
programming mode and returned to normal operation without saving any changes.
and OK
keys for one second, then release.