Rear Panel; Rack Installation - Omnitronic P-series Operating Instructions Manual

P-series power amplifiers
Hide thumbs Also See for P-series:
Table of Contents

Advertisement

Rear panel

(9) AC-CONNECTION
Used to plug the power cord in.
(10) FUSEHOLDER
Only replace the fuse when the device is disconnected from mains. Only use fuses of the same rating and
power.
(11) LIMITER
(12) MONO BRIDGE-OUTPUT SOCKET
For connecting the speakers in bridged mode.
(13) CH-2-SPEAKON-OUTPUT SOCKET
For connecting the speakers of channel 2.
(14) CH-2-BANANA/SCREW COMBINATION
For connecting the speakers of channel 2.
(15) CH-1-BANANA/SCREW COMBINATION
For connecting the speakers of channel 1.
(16) CH-1-SPEAKON-OUTPUT SOCKET
For connecting the speakers of channel 1.
(17) VR FOR LIGHT-CONTROL
For adjusting the LED-intensity.
(18) PARALLEL/DUAL/BRIDGE-MODE SELECTOR
For selecting the desired operation mode.
(19) CH-2 JACK INPUT SOCKET
Connect the input signal here using a balanced ¼" stereo jack.
(20) CH-2 XLR INPUT SOCKET
Connect the input signal here using a balanced XLR-plug.
(21) INPUT SENSITIVITY-SELECTOR
For selecting the desired input sensitivity.
(22) CH-1 XLR INPUT SOCKET
Connect the input signal here using a balanced XLR-plug.
(23) CH-1 JACK INPUT SOCKET
Connect the input signal here using a balanced ¼" stereo jack.
(24) GROUND LIFT-SELECTOR
INSTALLATION
RACK-INSTALLATION
This amplifier is built for 19" racks (483 mm). The rack you use should be a Double-Door-Rack where you
can open the frontpanel and the rear panel. The rack should be provided with a cooling fan. When mounting
the Amplifier into the rack, please make sure that there is enough space around the device so that the
heated air can be passed on. Steady overheating will damage your device.
You can fix the amplifier with four screws M6 in the rack.
Be careful when mounting the amplifier into the rack. Put the heaviest devices into the lower part of the rack.
Be aware that fastening the amplifier with four screws on the front panel is not enough. In order to ensure
safety, additional fastening by using ground and side bars is necessary.
18/34
10451130_V_2_1.DOC

Advertisement

Table of Contents
loading

This manual is also suitable for:

P-250P-500P-1000P-1500P-2000

Table of Contents