Assembly Instructions; Getting Started; Hardware Identification Chart; Step - York Fitness Inspiration 50026 Instruction Manual

ASSEMBLY INSTRUCTIONS

Getting Started

Place all parts from the box in a cleared area and position them on the floor in front of you. Remove all packing materials from
your area and place them back into the box. Do not dispose of the packing materials until assembly is completed. Read each
step carefully before beginning. If you are missing a part, please contact our technical support.
After unpacking the unit, open the hardware bag and make sure that you have all the following items. Some hardware may
be already attached to the part:
WARNING
It is very important to ensure that there are enough threads engaged
into the top of the selector stem.
Ensure the threads are engaged to a depth of at least 15mm. Eg. If
total bolt length is 45mm, the remaining thread should measure 30mm.
If bolt is not engaged as described, the threads may fail resulting in
unexpected sudden weight shift that could lead to serious injury.
Tools needed for assembly
• 2 x 19MM wrenches
• 2 x 17MM wrenches
• 1 x 15MM wrench
• Cross head screwdriver
• 6MM allen key

Hardware Identification Chart

This chart is provided to help identity the hardware used in the assembly process. Place the
washers, the end of the bolts, or screws on the circles to check for the correct diameter. Use
the small scale to check the length of the bolts and screws.
NOTE: The length of all bolts and screws except those with flat heads is measured
from below the head to the end of the bolt or screw. Flat head bolts and screws are
measured from the top of the head to the end of the bolt or screw.
6 • Inspiration Accomplish Home Gym | INSTRUCTION MANUAL