Table of Contents
Advertisement
• Select ANGLE TO WALL OR CORNER if this unit is
installed in the comer of your listening room. Adjust
the width and length of your listening room as well as
the distance of the listening position from this unit.
Listening position
from the unit
Room width
...
...:
Room length
Choices for the room width and length:
2.0 m to 12.0 m (6.5 ft to 40.0 ft)
Choices for the listening position from this unit:
1.8 m to 9.0 m (6.0 ft to 30.0 ft)
H) SETT ING
PH~:Ht'1ETERS
2,/3
MANUAL SETUP
•
BEAM ADJUSTMENT (Beam adjustment)
Use to manually adjust the various sound beam settings.
We recommend that you select 5 Beam as the beam mode
before adjusting these parameters (see page 56).
• When INSTALLED POSITION is adjusted in MANUAL
SETUP (see page 76), the factory default value is automatically
set for this parameter except Center in FOCAL LENGTH (see
page 78).
• Depending on the beam mode settings (see pages 56,57,62 and
63), some channel positions may not be available for selection.
In this case, "- -" is displayed. When using Stereo plus 3 Beam
as the beam mode, set the surround left and right signals to be
output from the front left and right channels.
B)BEHM HDJUSTMENT
~
a)HORIZONH1L
l7l~jGLE
b)BERM TRRUEL LHIGTH
c)FOCRL LENGTH
dHREBLE GRHI
[a]/[T]:
Up/Do~Jn
[ENTER]: Enter
Room width and
length
Listening
position from the
unit
~~----
5.4M
--~
1
[ 5.4M ]
I
-l-
[a]/[T]:Up/Down
[~]/[~]:Sel
[ENTER]: Return
+
[a]/[T]:Up/Down
[~]/[~]:Sel
[ENTER]: Return
HORIZONTAL ANGLE (Horizontal angle)
Use to adjust the horizontal angle of sound beams for each
channel. By adjusting the horizontal angle of the sound
beams, you can optimize the sound beam paths. A test
tone is automatically output.
,
---: ; i'
::>::---
(-) -
"
• •
- -
., (+)
(+) -
~----
"
-,--~,-
(-)
-----
-~~~-
,-",
-
,
-
,
Choices: L90° to R90°
Adjust toward L (left) to move the direction of the output
to the left and adjust toward R (right) to move it to the
right.
Front L
L65de9
When you set the INSTALLED POSITION parameter in
MANUAL SETUP (see page 76), the parameters newly set for
the width and length of your listening room are automatically set
as the factory default value.
a)HORIZONTHL HNGLE li5
5 beaM
c=::J
L90~R90
0(de9)
[a]/[T]:Up/[lown [....
]/[~]:Sel
[E~nER]
: Return
77
En
•
Advertisement
Table of Contents
