Yamaha YSP-3050 Owner's Manual page 62

En/oYlng surround sound
• Decoder indicators
Depending on the input source and the selected surround
mode, the decoder indicators in the front panel display
light up as follows:
Status Indicator
When PCM signals are being input
PCM
When DTS digital signals are being
....
input
When DTS Neo:6 is selected as the
surround mode
. . . . +
Neo:8
When Dolby Digital signals are
being input
[]C DIGITAL
When Dolby Pro Logic is selected
as the surround mode
IIlPL
When Dolby Pro Logic II is selected
as the surround mode
IIlPLlI
• You can select an input mode (AUTO, DTS, or ANALOG) by
pressing INPUTMODE repeatedly (see page 90).
• Discs encoded in DTS-ES, Dolby Digital 5.1 EX, Dolby Digital
EX, or Dolby Digital Surround EX will be played back in DTS
or Dolby Digital.
• Input channel indicators
Depending on the channel component of the current
digital input signal, the input channel indicators in the
front panel display light up as follows:
Status Indicator
When 2-channel stereo signals are
IY 18l
being input
When 5. I-channel signals are being
1Y19181
input
@
~
[ I J
58
En
• Surround modes and recommended
sources
"
Recommenc:l4ld' ,
S!Jrrouncll'Y1Ode ,' ,
" , S()Urc8
"
Dolby Pro Logic -
All sources
Movie Movies
Dolby Pro Logic II
Music Music
Game Games
DTS Neo:6
Cinema Movies
Music Music
Neural Surround
-
XM Satellite Radio
• When you select an input source (see page 39), the surround
mode used for the previously selected input source is
automatically selected.
• If the power of this unit is turned off and on again, the surround
mode used for the previously selected input source before the
power was turned off is automatically selected.
• If the surround modes are not available, "Prohibit" appears in
the front panel display when you press SUR. DECODE.
• The surround modes are available:
- when the beam mode is set to a setting other than the 2-
channel or 5-ehannel stereo playback (see page 62) and My
Surround (see page 57).
- when the CINEMA DSP programs are turned off
(see page 67).
- when the movie program is selected as the CINEMA DSP
program (see page 66). In this case, only Dolby Pro Logic,
Dolby Pro Logic II Movie, and DTS Neo:6 Cinema are
available.
- when 2-channel signals are being input.
- when the Music Enhancer is turned off (see page 68).