JVC MX-J150R Service Manual page 9

Removing the rear panel
1.
board and the tuner board to the rear panel on the
back of the body.
2. Remove the three screws J attaching the heat sink
to the rear panel on the back of the body.
3. Remove the three screws K attaching the rear panel
on the back of the body.
Removing the main board
Prior to performing the following procedure, remove
the rear panel.
1. Disconnect the harness from connector HCW1 of the
headphone board on the right side of the body.
Release the harness from the clamp in the body.
2. Disconnect the harness from head wire connector
DW1 and DW2 extending to the main board in the
body.
3. Disconnect the harness from connector RCW1 of the
power transformer.
4. Remove the screw L attaching the earth terminal to
the base chassis.
5. Remove the screw F attaching the front panel
assembly.
6. Disconnect connector CCW1 and CCW2 connected
to the main board.
(See Fig.14)
I attaching the main
(See Fig.15 and 16)
Rear panel
J
K
CCW1
CCW2
Clamp
RCW1
L
I
K
Fig.14
Front panel assembly
F
Headphone board
HCW1
Main board
Fig.15
DW1
Main board
DW2
Tuner board
Heat sink
Power transformer
Fig.16
I
I