JVC MX-J150R Service Manual page 16

<CD mechanism section>
•
Removing the CD mechanism holder from the CD
chassis to remove the CD mechanism.
(Refer to "Removing the CD mechanism holder
assembly" (Pag.2-11))
Removing the pickup unit.
1. Loosen the two screws A fixing the chassis.(Fig.1)
2. Removing the feed gear stopper c on the
bottom of the mechanism and pull out the gear.
(Fig.1, Fig.3, Fig.4)
3. Pull out the shaft by opening the pickup shaft
stopper outward to unlock.(Fig.1, Fig.2)
4. Removing the pickup unit.(Fig.1)
Removing the motor board.
1. Unsolder the motor terminal on the motor board.(Fig.3)
2. Remove the motor board.(Fig.3)
Removing the feed motor.
Remove the two motor fixing screws at
removing the feed motor.(Fig.1, Fig.3)
Removing the spindle motor.
The spindle motor cannot be removed as a single unit.
When removing the spindle motor, change the chassis
and turntable together as aunit.(Fig.5)
Stopper
B and
Motor board
Feed motor
Spindle motor
A
Shutter
Pickup unit
B
A
Shaft
Stopper
Unsolder
c
(Feed gear stopper)
Shaft
Feed Gear