Cd Changer Unit - JVC MX-J150R Service Manual

<CD changer unit>
Prior to performing the following procedure, remove
the CD changer unit.
Removing the CD tray (See Fig.26 to 28)
1.
under side of the CD changer unit in the direction of
the arrow and draw the CD tray toward the front until
it stops.
2. Disconnect the card wire from connector SCW5 of
the CD servo board on the upper side of the CD
changer unit.
3. Push down the two tray stoppers marked i and pull
out the CD tray.
Reinstall the CD tray
1. Align the gear-cam with the gear-tray as shown
fig.29, then mount the CD tray.
2. When assembling the CD tray, take extreme care not
engage with gear - synchro.
Gear-cam
Gear-convert
Gear-convert Gear-tray
c on the
(See Fig.29 to 30)
Gear-cam
timing point
Fig.29
Loading pulley gear marked c
CD tray
CD tray
Tray stopper marked i
Gear-tray
Gear-tray
CD tray
CD tray
Fig.26
Fig.27
Tray stopper marked i
CD servo board
SCW5
Fig.28
Gear-synchro
Fig.30