Table of Contents
Advertisement
4. Take hold of the plastic
drive release strip and
gently pull the drive out
of its compartment as
shown in the illustrations.
You might have to gently
move the drive slightly
side-to-side at first to
work it out of the SATA
and power ports.
5. Unscrew the existing drive
from its cage and replace
it with the new drive.
Once you have secured
the new drive into the
cage with the screws,
place it back into the
HDD/SSD compartment.
Be careful when aligning
the drive so the connec-
tors match up with the
SATA and power ports. If
you are properly aligned
with the compartment, it
should slide back in very
smoothly.
6. Slide the drive carefully
back into place.
7.
Replace the four (4)screws
that secure the drive.
8. After the drive is securely inserted, you can replace the cover
and secure it with the four (4) Philips head screws.
You are now ready to restore your system back up or install a
new version of your operating system. For more information on
restoring your operating system, refer to the section Restoring
Your Sahara NetSlate from the Troubleshooting chapter.
Chapter 06: Upgrading Your Sahara NetSlate
109
Advertisement
Table of Contents
