Table of Contents
Advertisement
Your Sahara NetSlate can accommodate one (1) DDR3, 204-pin
SODIMM module for a total of up to 4.0 GB RAM. The module is
located in the RAM compartment that is accessible on the back
panel of the Tablet PC.
NOTE: You can install a maximum of 4.0GB of RAM using one (1) 4.0GB
SODIMM module. The Sahara NetSlate can utilize up to DDR3-1066
(although faster DDR3 modules will work, just not at full speed). Check
with the dealer where you bought your Tablet PC if you are unsure
what type of RAM is in your system.
Refer to the following instructions and illustrations for informa-
tion on how to upgrade your computer's memory modules. Be
sure to follow the procedures in the previous section, Before you
Begin ANY Upgrade Procedure.
1. Turn off your Tablet PC, turn it over and place it face down
on a solid, flat surface. Be careful not to place it on some-
thing rough that could damage the LCD display.
2. Locate the RAM/3G
compartment in the
upper right quadrant
of the back panel of
the system (refer to the
Touring the Sahara Net-
Slate chapter to identify
this compartment). Re-
move the two (2) screws
that secure the vented
compartment cover (use
a #1 Philips head screw
driver).
3. Lift the cover from the
edge where the screw
holes are located to
remove it and set it
aside. Inside on the left
is the pre-installed RAM
SODIMM.
Chapter 06: Upgrading Your Sahara NetSlate
105
Advertisement
Table of Contents
