Table of Contents
Advertisement
Your Sahara NetSlate comes pre-configured with a data storage
drive that is easy to upgrade. Before installing a new HDD or SSD,
however, be sure to back up all of the files on your existing drive.
Refer to the following instructions and illustrations for informa-
tion on how to upgrade your computer's data storage drive. Be
sure to follow the procedures in the previous section entitled
Before you Begin ANY Upgrade Procedure.
1. Turn off your computer, turn it over and place it face down
on a solid, flat surface. Be careful not to place it on some-
thing rough that could damage the LCD display.
2. Locate the HDD/SSD
compartment near the
center of the Tablet PC
just below the docking
connector (refer to
the section Back View
in the Touring Your
Sahara NetSlate chapter
to identify this compart-
ment). Remove the four
(4) screws that secure the
compartment cover (use
a #1 Philips head screw
driver).
3. With the cover removed,
look inside the compart-
ment and you will see the
system's data drive sitting
in the bay. The drive is
held securely in place
by four (4) Philips head
screws. You'll need to
remove them in order to
replace the drive.
Chapter 06: Upgrading Your Sahara NetSlate
108
Remove the four Philips head screws
marked above that hold the drive in place.
Advertisement
Table of Contents
