Sony HCD-VZ50MD Service Manual page 30

4-5-1. Operating the Continuous Playback Mode
1. Entering the continuous playback mode
1 Set the disc in the unit. (Whichever recordable discs or discs for playback only are available.)
2 Move the multi-stick and display "CPLAY1MODE"(C34).
3 Press the PUSH ENTER button to change the display to "CPLAY1MID".
4 When access completes, the display changes to "C =
Note : The numbers " " displayed show you error rates and ADER.
2. Changing the parts to be played back
1 Press the PUSH ENTER button during continuous playback to change the display as below.
"CPLAY1MID" t "CPLAY1OUT" t "CPLAY1IN"
When pressed another time, the parts to be played back can be moved.
2 When access completes, the display changes to "C =
Note : The numbers " " displayed show you error rates and ADER.
3. Ending the continuous playback mode
1 Press the CLEAR button while REC IT is lit. The display will change to "CPLAY1MODE"(C34).
2 To remove the disc, press the MD Z button while REC IT is off.
Note : The playback start addresses for IN, MID, and OUT are as follows.
IN 40h cluster
MID 300h cluster
OUT 700h cluster
4-5-2. Operating the Continuous Recording Mode (Use only when performing self-recording/palyback check.)
1. Entering the continuous recording mode
1 Set a recordable disc in the unit.
2 Move the multi-stick and display "CREC 1MODE" (C35).
3 Press the PUSH ENTER button to change the display to "CREC 1MID".
4 When access completes, the display changes to "CREC1 (
Note : The numbers " " displayed shows you the recording position addresses.
2. Changing the parts to be recorded
1 When the PUSH ENTER button is pressed during continuous recording, the display changes as below.
"CREC 1MID" t "CREC 1OUT" t "CREC 1IN"
When pressed another time, the parts to be recorded can be changed.
2 When access completes, the display changes to "CREC 1(
Note : The numbers " " displayed shows you the recording position addresses.
3. Ending the continuous recording mode
1 Press the CLEAR button while REC IT is lit. The display changes to "CREC 1MODE" (C35 ) and
2 To remove the disc, press the MD Z button while REC IT is off.
Note 1 : The recording start addresses for IN, MID, and OUT are as follows.
IN 40h cluster
MID 300h cluster
OUT 700h cluster
Note 2 : Press the CLEAR button while REC IT is lit can be used to stop recording anytime.
Note 3 : Do not perform continuous recording for long periods of time above 5 minutes.
Note 4 : During continuous recording, be careful not to apply vibration.
30
AD = ".
AD = ".
)" and MD REC lights up.
MD REC goes off.
MD REC
)" and lights up.
MD REC
goes off.