Lcd Setup Functions - CyberPower OLS1000ERT2U User Manual

LCD INFORMATION READOUT
There are 12 types of UPS information available for display on digit area.
Information Submenu
OUTPUT XXX V
OUTPUT XX.XHz
OUTPUT XXX (k)VA
OUTPUT XXX% VA
OUTPUT XXX (k)W
OUTPUT XXX% W
INPUT XXX V
EVENT XXX
ESTIMATED RUN TIME
%
ESTIMATED RUN TIME
XX(.)X [Min][Hr]
TIME TO SHUT DOWN
XX(.)X [Min][Hr]
TIME TO TURN ON
XX(.)X [Min][Hr]
LCD SETTINGS CONFIGURATION
There are 8 UPS settings that can be configured by the user.
1. Press the "ESC" button simultaneously for 5 seconds to activate the setting mode.
The first configuration parameter will be displayed on the LCD screen.
Note: The manual settings programming mode can ONLY be invoked while UPS is in Bypass mode or Standby mode. To
make UPS on Standby mode or Bypass mode, connect utility power to UPS and do not turn on UPS.
2. Press the "ENTER" button to select the setting you want to configure.
3. Press the "▼" buttons to scroll through the different parameters.
Press the "ENTER" button to select the parameter you want.
4. Press the "ESC" button simultaneously for 5 seconds to cancel and exit setting mode. Press the "ENTER" button
simultaneously for 5 seconds to save all the settings you just do and exit setting mode.

LCD SETUP FUNCTIONS

Description
Displays the Output Voltage
Displays the Output Frequency
Displays the Output VA
Displays the Output Load Percentage of Maximum Apparent Power
Displays the Output Wattage
Displays the Output Load Percentage of Maximum Active Power
Displays the Input Voltage
Displays the Event ID
Displays the Estimated Percentage of Battery Capacity
Displays the Estimated Run Time with battery
Displays the Time Delay to Shutdown UPS
Displays the Time Delay to Restart UPS
11
Copyright © 2013 CyberPower Systems, Inc.