Tower And Glass Panels Installation - Jacuzzi Summer Rain 2 Wall and 3 Wall Installation And Operating Instructions Manual

3 WALL: TOWER AND CURVED GLASS INSTALLATION
STEP 1
Position the wall post so the edge of the post is set back
3/4" (19 mm) in from the finish wall.
STEP 2
Level the post in its proper position and mark where
screw holes are to be drilled. Drill 3/16" holes and secure
with wall anchors and screws provided. Cut a 12" strip
of tape (provided) and apply firmly over screw heads.
FINISH WALL
3/4"
(19 mm)
TAPE
3 PLACES)
STEP 3
Slide the glass panel into the wall post. Make sure that
the corner notch is positioned toward the base of the
tower.
STEP 4
Place the tower onto base. Ensure the curved glass
locates into the glazing channel. Install bolt but do not
tighten.
19
NOTCH
BOLT (5/16")
WASHER
GLAZING
CHANNEL