Sony KDL-32SL130 Service Manual page 50

KDL-40SL130 ONLY
U1 BOARD
Align with ribs on bezel channel
Check Sheet Core C is installed along edge of DTT shield
and start of straight edge of DTT shield.
[INSTALLED BY VENDOR]
KDL-32SL130/40SL130
1
3
2
3
Align with center of circles on
panel rib.
3/4/2007 LATE CHANGE:
ADD
3x12mm Screw in this
hole!
2
KDL-32SL130/40SL130
OPERATION PROCESS
1. Apply Sheet Core A to Panel in location
where U2 bracket is to be installed
(Use plastic ribs on bezel as guide)
2. Make sure DTT Shield has Sheet Core C
Install Sheet Core C on "dimple" of panel
to secure cables to panel.
3. Wire Dress 20P Harness as shown.
Put attention on DIRECTION of wires from
BU-Bd inside side clamp on DTT Shield!
50