Table of Contents
Advertisement
Commands
DL
Usage:
DL <offset>
The DL command performs an S-record download of data obtained from the console typically
through a serial port. The value for offset is converted according to the user-defined radix, normally
hexadecimal.
If offset is provided, then the destination address of each S-record is adjusted by offset.
The DL command checks the destination download address for validity. If the destination is an
address outside the defined user space, then an error message is displayed and downloading
aborted. DL can be used for downloading to internal flash, external flash, internal SRAM, and
external SRAM.
If the S-record file contains the entry point address, then the program counter is set to reflect this
address.
Examples:
To download an S-record file through the serial port, the command is:
dl
To download an S-record file through the serial port, and add an offset to the destination address
of 0x40, the command is:
dl
0x40
3-16
Download Console
MPC564EVB User's Manual
Advertisement
Table of Contents
