Intended Use; Orbital Sanding; Operating Instructions - Worx WX646 Safety And Operating Manual

oPerating inStrUCtionS

Note: Before using the tool, read the instruction
book carefully.

INteNDeD USe

The machine is intended for dry sanding of wood,
plastic, filler and coated surfaces.
1. fIttING tHe SANDING PAPeR (See fig. A)
Fit the paper over the pad so that it covers the entire
area. Make sure the sanding paper is even with the
edges and that the dust collection holes in the pad and
sanding paper is aligned and the sanding paper evenly
overlaps the pad. Never use your sander without a
sanding paper.
2. USING tHe DUSt ADAPteR (See fig. B)
Your sander is equipped with a dust adapter, which
is designed for collecting dust task. Insert the dust
adapter into the rear dust outlet of sander. Then pull
the dust adapter and make sure it is tightened securely
on the dust outlet. Then connect the hose of a vacuum
cleaner. First please turn on the vacuum cleaner, then
turn on the sander. If you stop sanding, first turn off the
sander, then turn off your vacuum cleaner.
3. oN/off SWItcH
To start your sander, depress the protective cover
over the switch at the position marked"I" . To stop your
sander, depress the protective cover at the position
marked "0" .
4. flUSH SANDING fAcIlIty
Your sander can sand flush on three sides of the base-
plate which allows easy access to corners and edges of
moulding.

5. oRBItAl SANDING

Your sander operates in small circular rotations which
allows efficient material removal.
Operate your sander in long sweeping movements
across your workpiece and even across the grain. For a
finer finish, always use a fine grain sandpaper and only
move the sander in the direction of the grain and never
across the grain.
Do not allow your sander to remain in the same
position otherwise you will remove material and create
and uneven surface.
6. cHANGe tHe BASeS (See fig. c, D)
1) Remove the 5 Phillips head screws holding the
Palm sander
A
B
C
6
D
WX646 WX646.1