Intended Use; Operating Instructions - Worx WX820 Safety And Operating Manual

from the declared value depending on the ways in
which the tool is used especially what kind of
workpiece is processed dependant on the following
examples and other variations on how the tool is used:
How the tool is used and the materials being cut or
drilled.
The tool being in good condition and well maintained.
The use of the correct accessory for the tool and
ensuring it is sharp and in good condition.
The tightness of the grip on the handles and if any anti
vibration and noise accessories are used.
And the tool is being used as intended by its design
and these instructions.
This tool may cause hand-arm vibration syn-
drome if its use is not adequately managed.
WARNING: To be accurate, an estimation of
exposure level in the actual conditions of use
should also take account of all parts of the operating cycle
such as the times when the tool is switched off and when it
is running idle but not actually doing the job. This may
significantly reduce the exposure level over the total
working period.
Helping to minimise your vibration and noise exposure risk.
Always use sharp chisels, drills and blades.
Maintain this tool in accordance with these instructions
and keep well lubricated (where appropriate).
If the tool is to be used regularly then invest in anti vibration
and noise accessories.
Plan your work schedule to spread any high vibration tool
use across a number of days.

4. INTENDED USE

This machine is intended for dry sanding of wood,
plastic, filler and coated surfaces. The sander is not to
be used for plaster or spackle.
5-in-1 Multi Sander

5. OPERATING INSTRUCTIONS

NOTE: Before using the tool, read the
instruction book carefully.
ASSEMBLY AND OPERATION
ACTION
ASSEMBLY
Fitting &Replacing the Sanding
Plate
Note: Read and understand the
instructions before assembling or
changing sanding plates.
Note: Open the Hyperlock lever
completely when attaching or
removing a sanding plate.
Note: When assembling the finishing
plate/detail plate, first check the
assembling direction.
WARNING!The sanding plate
must be attached before
starting the sander.
WARNING! Avoid pinching
hands and fingers when
using the Hyperlock™.
WARNING! Do not touch the
bottom fan after use to avoid
high-temperature burns.
Fitting the Sanding Paper
Attaching the Dust Bag
Caution:
To prevent the possibility of
dust or a foreign body being thrown
into your face or eyes, never attempt to
use your sander without the dust bag
properly installed.
Charging the Battery Pack
Installing the Battery Pack
OPERATION
Switching On/Off
FIGURE
See Fig.
A1-A8
See Fig.
B1-B6
See Fig. C
See Fig. D
See Fig. E
See Fig. F
WX820
WX820.X
13