Témoin Indicateur; Ice Maker - Whirlpool Upright Freezer Use & Care Manual

Door Ajar Alarm (on some models)
The temperature monitor alarm is located to the left of the
temperature control and sounds an audible alarm if the
temperature reaches 10°F (-12°C) or more above normal for the
selected setting.
The alarm is controlled by a three position switch.
| The proper setting for normal freezer use. The alarm
is on and the amber light will be illuminated.
0 The alarm is off.
✔
Tests the alarm.
Mullion Heater
The mullion heater is located between the upper and lower doors
near the center hinge. When activated the heater prevents
moisture from forming between the doors.
The heater is controlled by a two position switch:.
| The mullion heater is on.
0 The mullion heater is off.
Témoin indicateur
(sur certains modèles)
Un témoin indicateur vous assure que le congélateur fonctionne.
Si le témoin indicateur n'est pas illuminé, vérifier immédiatement
s'il existe :
■ Une panne de courant.
■ Un cordon électrique non branché.
■ Un disjoncteur de circuit ouvert ou fusible grillé.
■
Une ampoule de témoin indicateur grillée.

Ice Maker

(on some models)
To Turn the Ice Maker On/Off
NOTE: Do not force the wire shutoff arm up or down.
■ To turn the ice maker on, simply lower the wire shutoff arm.
NOTE: Your ice maker has an automatic shutoff. As ice is
made, the ice cubes fill the ice storage bin and the ice cubes
will raise the wire shutoff arm to the OFF (arm up) position.
24
■ To manually turn the ice maker off, lift the wire shutoff arm to
the OFF (arm up) position and listen for the click to make sure
the ice maker will not continue to operate.
Shut Off Arm
When installing an ice maker kit, it is necessary to replace the
shut off arm that is included with the kit, with the longer one
supplied with the freezer.
Portable Ice Bin
The ice bin may be used as a storage container or a portable ice
bucket.
The lid must be open when used as an ice bin.
Close the lid to use as a portable ice bucket or storage container.
Ice Production Rate
The ice maker should produce approximately 7 to 9 batches of
ice in a 24-hour period. If ice is not being made fast enough, turn
the Temperature Control toward a higher (colder) number in half
number steps. (For example, if the control is at 3, move it to
between 3 and 4.) Wait 24 hours and, if necessary, gradually turn
the Temperature Control to the highest setting, waiting 24 hours
between each increase.