INSTRUCTIONS BEFORE USING THE APPLIANCE SAFEGUARDING THE ENVIRONMENT PRECAUTIONS RECOMMENDATIONS CONTROL PANEL DESCRIPTION USE OF ICE MAKER AND WATER FILTER (SELECT MODELS) GUIDE TO INTERNAL GUIDE TO STORAGE FOOD ... PAGE 206 MAINTENANCE TROUBLESHOOTING SERVICE ... PAGE 209 AFTER-SALES SERVICE ... PAGE 210 INSTALLATION WATER CONNECTION...
BEFORE USING THE APPLIANCE • Your new appliance is designed exclusively for domestic To get the most out of your new appliance, read the user handbook thoroughly. handbook contains a description appliance and useful tips for storing food. Keep this handbook for future consultation.
• Do not store glass containers with liquids in the freezer since they may burst. • Do not eat ice cubes or ice Iollies immediately after taking them out of the freezer since they may cause cold burns. • Before carrying...
• If the temperature istoo warm or too cold in the refrigerator or freezer, first check the air vents to be sure they are not blocked before adjusting the controls. See "Ensuring Proper Air Circulation".
The Fast Cooling & Fast Freezing feature assists with periods of high refrigerator use, full grocery loads, or tern porarily warm room temperatures. • Press the Fast Cooling & Fast Freezing touch pad to set the freezer and refrigerator to the lowest temperature...
((2 or F) or (ON or OFF) will appear in the Refrigerator display. 2. Use the Freezer (+) or (-) touch pads to scroll through preference names. When the desired preference press the Refrigerator (+) or (-) touch pads to change the preference status.
Operating Instructions • Confirm ice bin isin place and ice maker arm is down. • After freezer section reaches between ice maker fills with water and begins operating. You will have a complete harvest of ice approximately every three hours.
WATER FILTER (SELECT MODELS) Water Filter Removal and Installation [f your appliance must be connected operate the water dispenser and/or ice maker, it must be a water supply which delivers potable water only. Ice makers not connected to a mains water supply must be filled with potable water only. Initial Installation The water filter is located in the upper right-hand...
GUIDE TO INTERNAL Shelves • Never attempt to adjust a shelf that is loaded with food (except in the case of the lift shelf). • Confirm shelf is secure before placing items on shelf. Your refrigerator has either spill guard glass shelf or non- sealed Shelves.
To Install: • Reverse the removal procedure. position. • When the sliding shelf is pushed to the rear, it will reposition the rear latches to their correct The Crisper Top serves as the lower fresh food shelf. To Remove the Crisper Top: •...
The party chiller keeps beverages and other items cooler than the rest of the fresh food section. A cold air inlet allows air from the freezer section to pass into the beverage chiller. The party chiller control is located on the left wall of the fresh food compartment.
• Pull shelf out to fu II extension. Tilt up front of shelf and pull straight out. To Install: • Insert shelf into freezer liner rails and push to back of compartment. Tilt up front of back until it falls into and lift it out.
Upper Wire Basket To Remove: • Pull upper basket out to full extension To Install: • Slide upper basket into freezer, lake hooks behind rail catch. Accessories (select models) Ice Cube Tray The Ice Cube Tray provides an area to freeze cubes for manual dispensing of ice.
When sealingthe food in bags, squeeze out the air (liquids need head space to allow for expansion). Seal the top of the bag with a fastener. Place labels on the inside of clear freezer bags: use self-adhesive labels on the outside of opaque ones...
FOOD STORAGE CHART Storagetime will vary accordingto the qualityof the food, the type of packaging or wrap used(moisture and vapour proof), and the storage temperature FOODSTUFF STORAGE i i ii ,!i,i,i!i,ii,ll !i!!i!!il Concentrated fruit juice 12 months Fruit (in general) 8 to 12 months and fresh fruit tO 6 months...
3. Remove the cover. 4. Remove light bulb. 5. Replace bulb with appliance bulb no greater 6. Insert front tabs of light cover into slots in freezer liner and snap rear portion over light assembly until rear tab engages. CLEANING...
If your ice maker does not work: • Has the freezer had enough time to become cold? With a new refrigerator • Is the ice maker ON/OFF? • Is the water turned on? Is water getting to the ice maker? •...
Dry any dampness on food containers before placing or the ice maker are not out of position.
• Secure refrigerator to dolly firmly with straps or bungee cords. Thread straps th rough handles when possible. Do not overtighten. Overtightening restraints may dent or damage outside finish. and freezer corn partments If you sell the appliance during transport...
DOOR DRAWER REHOVAL Some installations require door/drawer refrigerator its final location. Disconnect power to refrigerator before removing doors or drawer. Connect power only after replacing doors or drawer. Door removal To Remove: I. Unplug power cord from power source. 2. Remove toe grille and bottom hinge cover (see page 214).
5,With rails pulled out to full extension, down into the basket cradles. 6. Slide upper basket into freezer. Make sure that rear of basket hooks behind rail catch. damage, you will instructions. set the basket straight...
6 mm or half bubble higher than back of refrigerator the refrigerator is level from side to side. 6.Turn stabilizing legs (C) clockwise 7. Freezer drawer models only: Turn adjustment counterclockwise to allow the full weight of the refrigerator to rest on the stabilizing legs.
Handles If not installed, the handle is located in the interior food section or attached to the back of your refrigerator. Remove and discard handle packaging and tape. Handle design varies from refrigerator Please reference the appropriate instructions below. Fresh Food Handles Front Mount...
Freezer Handles Partial-Width Handle Materials Needed • Phillips screwdriver To Install: I. Install handle by fastening with screws removed door. • [freversingfreezerdoor. removedoor door and insert into screw holes. To Remove: Remove handle screws with Phillips screwdriver screws for later use.
Plastic handle removal card (or 0. I cm thick plastic card), Retain the card. Notes • There is a slight curve to this style of freezer handle. For proper installation, be sure handle is oriented as shown. To Install: I .Align door handle clips slightly to the left of the tabs attached to the freezer door.
i / i Whe n the left door isclosed, the hinged section automaticallyforms WATER CONNECTION Disconnect the appliance from the mains power supply before starting operations. • The ice maker and water circuit must be connected to a water supplyof potable and/or chemicallypurified water. •...