Akai AK22FLEDCG Instruction Manual page 35

PVR and Time Shift Operation (Cont.)
Important Notes
When using the Media function, remember the following important points:
• We strongly recommend you back up all data in the USB storage device to another storage
device so you do not risk losing any data in case of an unexpected device failure or accident.
We do not assume liability for any loss of data due to misuse or malfunction. Data backup
is your personal responsibility.
• You cannot change to a channel from another broadcaster or select another function while in
recording mode.
• If the signal is interrupted or removed while in recording mode, the recording will stop until
the signal is established. This may cause you to lose program content.
• Do not turn the TV off during recording, otherwise the TV will exit the PVR function and turn
to standby mode.
• The file recorded can only be used in this TV. Do not copy it to any other device.
• When you are in PVR recording mode, you may experience some difficulty with a scheduled
recording at different times without removing the USB recording device. You will need to
remove the USB device as it is required to reset after each recording to protect the device
from damage. You may also see the message 'DISK NOT READY' displayed. Remove the device,
reconnect and proceed with your recording.
• Some USB storage devices may not be compatible for smooth operation with this TV.
• For large file sizes and large capacity storage devices, the loading speed may be longer.
• The recognition speed of a USB storage device may vary depending on the device.
• When connecting or disconnecting the USB storage device, ensure the TV is not in Media
mode, otherwise the USB device or the files stored in it may be damaged.
• Only use a USB storage device formatted in a FAT32 file system provided with the Windows
operating system. If it is formatted by a different utility program that is not supported by
Windows, it may not be recognized.
• Ensure any USB devices connected to the TV do not use/exceed 500mA power rating.
• An "Unsupported File" message will be displayed if the file format or code is unsupported or
corrupted. (Refer to specifications table on page 43 for supported file types.)
35